Making Calls; Adjusting The Receiver Volume; Handsfree Facility - AUDIOLINE DECT 4800 Bedienungsanleitung

4.3

Making calls

1. Enter the required telephone number with a maximum of 18 digits using the
number pad. The numbers pressed are shown in the display. If more than
16 digits are pressed, the
appear and the last 16 digits will be shown.
2. Press the call button
The call duration in minutes and seconds is shown in the display during a call.
Ten seconds after dialling, the display will switch from showing the number
dialled to showing the duration of the call. The call duration will still be
retained in the display for a few seconds after the call has been ended.
3. To end the call, press the call button
station.
Note: If you have entered a number incorrectly, you can delete the number by
repeatedly pressing the
the button for a long time.
You can also get a dialling tone by first pressing the call button
digits of your required phone number, your telephone will dial the number directly.
With this method of making a call, it is not possible to correct individual digits in the
number in the manner described above.
4.4

Adjusting the receiver volume

There are three volume levels available to you if you should want to change the
receiver volume on the handset.
Press the selection buttons during a call to change the receiver volume.
The selected volume will be shown in the display.
= Loud
4.5

Handsfree facility

Press the handsfree button
are speaking to over the loudspeaker in the handset.
Press the handsfree button
70
- Operation -
indicator on the left-hand edge of the display will
and the required connection will be made.
button. The number is completely deleted by pressing
= Medium
during a call. You will now hear the person you
again to switch off the handsfree facility.
or replace the handset on the base
= Soft
. On entering the