Technical Data - FLORABEST FALHS 18 A1 Originalbetriebsanleitung

Technical data

Cordless long-reach hedge trimmer:
FALHS 18 A1
Rated voltage:
Nominal stroke speed: 2100 spm
Cut length:
Tooth spacing:
Battery pack:
Type:
Cells:
Rated voltage:
Capacity:
Energy value:
High-speed
battery charger:
INPUT:
Rated voltage:
Power consumption:
OUTPUT:
Rated voltage:
Charging current:
Charging time:
Fuse (internal):
Protection class:
Noise and vibration data:
Noise measurement value determined in ac-
cordance with EN ISO 10517 and directive
2000/14/EC. The A-rated noise level of the
power tool is typically as follows:
Noise emission value:
Sound pressure level: L
Uncertainty:
Sound power level:
Uncertainty:
Wear hearing protection!
FALHS 18 A1
(Direct current)
18 V
approx. 410 mm
16 mm
FALHS 18 A1-1
LITHIUM ION
5
(Direct current)
18 V
2.0 Ah
36 Wh
FALHS 18 A1-2
230–240 V ~ , 50 Hz
(Alternating current)
60 W
(Direct current)
21 V
2.4 A
approx. 60 min.
T3.15A
3.15 A
II /
= 71 dB(A)
pA
K = 3 dB(A)
pA
L = 84 dB(A)
pA
K = 3 dB(A)
wA
Total vibration values (vector total of three direc-
tions) determined in accordance with EN ISO 10517:
Total equivalent vibration value:
a < 2,5 m/s 2
h
Uncertainty K = 1.5 m/s
WARNING!
■ Also reduce the risk due to vibrations, e.g. the
risk of Raynaud's phenomenon, by taking fre-
quent breaks and rubbing your hands together!
NOTE
► The vibration level specified in these instructions
has been measured in accordance with the
standardised measuring procedure specified
in EN ISO 10517 and can be used to make
equipment comparisons. The specified vibration
emission value can also be used to make an
initial exposure estimate.
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions in
some cases. Regularly using the electric tool in
such a way may make it easy to underestimate
the vibration. Try to keep the vibration loads
as low as possible. Measures to reduce the
vibration load are, e.g. wearing gloves and
limiting the working time. Wherein all states of
operation must be included (e.g. times when
the power tool is switched off and times where
the power tool is switched on but running
without load).
2
GB
21