Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery Pack (See Fig. A); Attaching/Disconnecting The Battery Pack To/From The Appliance - FLORABEST FALHS 18 A1 Originalbetriebsanleitung

Check the hedge for hidden objects
■
(e.g. wire fences).
GB
RESIDUAL RISKS!
■ Even if you operate this power tool properly,
there will still be residual risks. The following
risks can occur in the context of the design and
construction of this power tool:
■ a) Cuts
■ b) Hearing damage, if no suitable hearing
protection is worn.
■ c) Damage to health caused by hand-
arm vibrations if the appliance is used for
extended periods or is not properly used and
maintained.
NOTE
► The hedge trimmer is supplied completely
assembled.
► Notes and diagrams of the settings, mainten-
ance and user lubrication can be found in this
guide.
► Notes on exchange and repair (see section
Maintenance and cleaning/service).
► Explanation of all graphical symbols used on
the hedge trimmer and technical data can be
found in this guide.
► The features of the hedge trimmer can be
found in the technical data.
► Blocked tool: remove any blockages from the
cutter bar
Original accessories/
auxiliary equipment
■ Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury.
28
.

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you re-
move the battery pack
battery pack to the high-speed charger
■ Never charge the battery pack when the ambi-
ent temperature is below 10°C or above 40°C.
♦ Connect the battery pack to the high-speed
charger (see Fig. A).
♦ Insert the power plug into the socket. The control
LED lights up red.
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
♦ Fit the battery pack back onto the appliance.
■ Never recharge a battery pack again immedi-
ately after rapid charging. This could overcharge
the battery pack, thus reducing the lifespan of
the battery and charger.
♦ You should always switch the high-speed charger
off for at least 15 minutes between successive
charging processes. Also disconnect the power
plug from the mains power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Allow the battery pack
handle .
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge/
performance
♦ RED/ORANGE = medium charge/performance
♦ RED = low charge – charge the battery
from or connect the
.
indicates that the
to click into the
and remove the
to
as follows:
FALHS 18 A1