GB
High horizontal
cutting:
Motor unit
set at
75°, telescopic handle
extended
Adjusted motor unit angle
NOTE
►
For high and low cutting, you can adjust the
angle of the motor unit
75° to –60°.
♦
Removing the battery pack
ance (see chapter "Attaching/disconnecting
the battery pack to/from the appliance").
♦
Press the two release buttons
time.
♦
Adjust the angle of the motor unit
desired direction.
♦
Let go of the release buttons
unit will click into place.
♦
Replace the battery pack
(see chapter "Attaching/disconnecting the
battery pack to/from the appliance").
Transport and storage
■
Disconnect the battery pack
and storage.
■
Use the protective case
appliance.
■
Ensure that the appliance cannot switch on
during transport.
■
Always clean the appliance thoroughly before
storing.
30
Low cutting:
Motor unit
set at
–60°, telescopic
handle
extended
in 15° steps from
from the appli-
at the same
in the
and the motor
on the appliance
before transport
for transporting the
■
Store the appliance in a dry place and out of
the reach of children.
■
Store the appliance horizontally or secured
against falling.
Cleaning and maintenance
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the appliance.
■
Use a soft, dry cloth to clean the housing. Never
use petrol, solvents or cleansers which can dam-
age plastic.
■
Check the hedge trimmer for loose screws on
the cutter bar
and tighten these if necessary.
■
Remove stuck cuttings.
■
Maintain the cutter bar
an oil can.
■
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
climate is cool and dry.
with an oil spray or
FALHS 18 A1