Elica NIKOLATESLA FIT 3Z BL/A/72 Montage- Und Gebrauchsanweisungen Seite 20

time; an acoustic signal will be emitted at the end of the
countdown.
Note: When the remaining time is less than 10 minutes, a
fixed dot will appear in the timer after the first number.
Displayed value
To switch off the Timer:
• select Zone/Display (4)
• set the duration of the Timer to Zero
(5)
● Temperature Manager (Warming Function)
Temperature Manager is a control function that allows the
maintaining of heat at a constant temperature, at an
optimised power level; ideal to keep ready-cooked foods
warm. The Temperature Manager function is activated the
first time the key (8) is pressed.
The symbol appears in the display (2) of the zone that is
working in the Temperature Manager
Note: by selecting another cooking zone at the same time,
the symbol (8) will go back to being illuminated with
light intensity, and it will be possible to proceed, also for
this zone, with the activation of the function; in any case,
the function remains active in the zone in which it has
already been set, as indicated in the Display (2).
• Press (8) again to deactivate and switch off, until the
level shown in the Display (2) is brought to
Note: if there are several zones operating in Temperature
Manager (Warming Function) mode, select the desired
zone first using the Selection zone (2); the function can
also be deactivated using the Selection bar (3), by
bringing the Power Level to
USING THE EXTRACTOR
● Switching the extraction system on:
• Switch on the hob as indicated in the "Power-on" chapter
on "using the hob";
• Open the Flap; Touch the Selection zone (12) to activate
the extraction system.
Note: The extractor zone is fitted with a mechanical
rotating FLAP. The FLAP must be opened before
switching on the hood to activate the extraction
system. The hood has a sensor which when the extractor
is on stops the motor automatically if the FLAP is closed.
The suction function restarts only when the FLAP is
reopened. See the instructions given in the illustrated part
of this manual.
Remaining time
1h and 35 min
1min. and 35 sec.
, using
.
.
● Extraction speed (power):
The extractor has 4 speed (power) levels from
Touch and slide your fingers along the Selection bar (3):
to the right to increase the power level, to the left to
decrease the power level.
Note: The set power level will be displayed in the
Selection/Display area (12)
● Power Booster
The extractor is equipped with 1 additional extraction level
called Power Booster; it is timed and it lasts 5 minutes.
To select it, touch and slide your fingers along the
Selection bar (3) (beyond the level
symbol will be displayed:
Note: after the five minutes, the power will go back to the
previously set level.
● Automatic mode
The hood will turn on at the most suitable speed, adapting
the extraction capacity to the maximum cooking level used
in the cooking zones.
When the cooking zones are switched off, the hood adapts
its extraction speed, decreasing it gradually, to eliminate
residual vapours and odours.
To activate this function:
Press (14);
Repeat the operation to deactivate.
Note: if, during automatic operation, the speeds from
are selected using the Selection bar (3), automatic
operation is interrupted; if, on the other hand, the Power
Booster is selected, automatic operation will resume at the
end of the timer and, in the meantime, the symbol
keeps flashing.
Note: if the hob automatically shuts down with Automatic
mode active, the extractor fan will automatically turn off
gradually.
● Filter saturation indicator
The hood indicates when filter maintenance is needed:
For the carbon/ceramic odour filters, FILTER (13) lights up
For the grease filter, FILTER (13) lights up and flashes
Note: this function is disabled by default (see how to
enable it in the paragraph "Activation of filter saturation
indicator")
● Reset filter saturation
After performing maintenance on the filters (grease and/or
carbon/ceramic) press and hold FILTER (13); it will turn off
and the indicator counter will restart.
20
to
); this flashing
.
,
to