Elica NIKOLATESLA FIT 3Z BL/A/72 Montage- Und Gebrauchsanweisungen Seite 19

is connected to the mains, or reconnected to the mains,
within the next 2 minutes.
To set the Power Limitation:
• press (which will flash, only for the first 2 minutes
after the product has been switched on)
• while holding down
sequence, FR-2 then RR-2 and finally CL-2 of the cooking
zones Display (2), as shown in the figure below; each time
a key is pressed, you will hear a short beep; once this
sequence is complete, it will be possible to release the
keys.
At this point, the Display (RR-2) will show, in alternating
sequence, the symbols
setting can be made.
• select the Display (RR-2) then slide along the Selection
bar (3), until the Display shows the symbols
alternating sequence;
The Display (CL-2) will show the current setting (default
setting corresponding to 7.4KW) which can be changed
as indicated in the table below:
Displayed value Power (Kw)
7.4 Kw (default setting)
4.5 Kw
3.1 Kw
To change the Power Limitation setting:
• press the Display (CL-2) then slide along the Selection
bar (3), to
set the new setting. To save the selection made, press the
ON/OFF (1) button for 2 seconds; an extended audible
signal will be emitted to confirm the setting.
● Key Lock
The Key Lock allows you to lock the settings of the hob to
prevent accidental tampering with the same, while leaving
the set functions enabled.
Activation:
• press (10) Repeat the operation to deactivate.
Note: if any other function is pressed while the Key Lock is
active, the symbol will flash to indicate that the function
is in use and must be deactivated if necessary in order to
, press, one at a time, in
and , indicating that the
and
use the hob.
● Automatic Heat UP
The Automatic Heat UP function allows the set power to be
reached more quickly; with this function it is possible to
cook food faster without the risk of burning it, insofar as the
temperature does not exceed the set level. This function is
available for power levels from
Activation:
• with the cooking zone on, press
will show a flashing
the cooking zone.
By increasing the power level of the cooking zone: the
Automatic Heat Up function remains active, with the new
temperature setting;
By decreasing the power level of the cooking zone: the
Automatic Heat Up function is deactivated.
Note: by selecting another cooking zone at the same time,
the symbol (7) will go back to being illuminated with
light intensity, and it will be possible to proceed, also for
this zone, with the activation of the function; in any case,
the function remains active in the zone in which it has
in
already been set, as indicated in the Display (2).
● Pause
The Pause function allows active functions on the hob to be
suspended, bringing the cooking power to zero.
Activation:
• press (9), the symbol
To deactivate the function:
• press (9) the Selection bar (3) will light up
• press/slide on the Selection Bar (3) to deactivate the
function.
Note: deactivation restores the conditions of the hob before
the pause; the hob continues to work with the same
settings previously set.
Note: if after 10 minutes, the Pause Function is not
deactivated, the hob will turn off automatically.
Note: the Pause Function does not affect the extraction.
● "STAND ALONE" Timer
The Timer function is a countdown independent of the
cooking zones (and the extraction zone).
The Timer is activated by pressing the Zone/Display (4).
Use the symbols
Timer, which is shown in the Zone/Display (4)
Note: wait 10 seconds without pressing any other
command, so that the countdown starts.
The Timer can be set up to a maximum of 1(h) and
59(min.) The Zone/Display (4) will show the remaining
19
to .
(7), the Display (2)
, alternating with the power set in
will flash on the display (2)
(5) to set the duration of the