General Information; General Information - Agilent Technologies Turbo-V 1000 ICE Bedienungshandbuch

16 Instructions for Use

General Information

General Information

This equipment is intended for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not be
held responsible for any events occurring due to non-compliance, even
partial, with these instructions, improper use by untrained people, non-
authorized interference with the equipment or any action contrary to
that provided for by specific national standards. The Turbo-V 1000 ICE
series controllers are microprocessor-controlled, solid-state, frequency
converters with self-diagnostic and self-protection features.
The controllers drive (within ten steps) the Turbo-V 1000 ICE pump
during the starting phase by controlling the voltage and current respect
to the speed reached by the pump. They incorporate all the facilities
required for the automatic operation of the Turbo-V 1000 ICE pump
series.
Remote start/stop commands, pump status signals, forepump start/stop
commands, interlock control signals (for pressure switch, water flow
switch), heater jacket control signals, flow meter control signals and
purge valve management signals are provided via auxiliary connectors.
The following paragraphs contain all the information necessary to
guarantee the safety of the operator when using the equipment. Detailed
information is supplied in the appendix "Technical Information".
194/268 Turbo-V 1000 ICE Controller User Manual / 87-900-905-01 (M)