Reely ATOMIC - 680 Rennboot RTR Bedienungsanleitung Seite 31

• If the model boat stops working and starts to float across the water, do not endanger yourself or others
when attempting to retrieve it from the water.
Do not take any risks when attempting to retrieve the model boat from the water. Watch out for currents
and other boat traffic in the body of water. If necessary, use an aid to retrieve the model boat from the
water (e.g. rowing boat). Never attempt to retrieve the model boat by yourself. Ask someone to stay on
shore so that they can rescue you in the event of an emergency.
• Never point the remote control antenna directly at the model boat, as this significantly impairs transmis-
sion.
• The motor, speed controller and battery may heat up when the model boat is in use. For this reason,
allow the boat to cool down for 5 - 10 minutes before charging or replacing the battery. Allow the motor
to cool down to room temperature.
• Always leave the remote control turned on when the model boat is in use. After use, disconnect the
battery or turn the boat off before switching off the remote control.
• In the event of a fault or malfunction, establish the cause of the problem before using the model boat
again.
• Do not expose the model boat or the remote control to direct sunlight or excessive heat for prolonged
periods.
31