Technical Specifications - Kärcher KM 70/40 W G Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

Fault

Appliance cannot be started

Engine is running but machine is

not moving

Device comes to halt while climb-

ing a slope

Machine is not sweeping properly Check roller brush and side brushes for wear, replace if necessary.

Dust gathers in the machine

Poor cleaning performance at edg-

Side-brush raising does not func-

tion

The new roller brush brushes

against the waste container

Machine data

Length x width x height (pushing handle unfolded)

Length x width x height (pushing handle folded in)

Unladen weight

Driving and sweeping speed

Climbing capability (max.)

Roller brush diameter

Side brush diameter

Surface area, max.

Working width without side brushes

Working width with side-brush

Volume of waste container

Protection type, drip-proof

Engine

Troubleshooting

Remedy

Close appliance hood

Check the hood contact switches

In order to start the device with the starter rope, turn the key switch to position "1".

Refuel

Open fuel cock

Check and clean spark plug, replace if necessary.

Check setting of multifunctional lever

Check bowden cable to the motor

Inform Kärcher Customer Service.

Adjust the Bowden cable of the acceleration drive

Checking the V-Belt

Inform Kärcher Customer Service.

Drive over a path with lesser slope

Adjust the Bowden cable of the acceleration drive

Checking the V-Belt

Inform Kärcher Customer Service.

Check function of bulk waste flap

Release the Bowden cable of the bulk waste flap (adjustment screw)

Check belts for tension and functioning; replace, if required

Adjust roller mirror

Replacing roller brush

Inform Kärcher Customer Service.

Check function of bulk waste flap

Release the Bowden cable of the bulk waste flap (adjustment screw)

Check dust filter, clean or replace

Empty waste container

Replace sealing profile at the waste container

Check the seal on the dust filter

Check sealing strips for wear, adjust or replace as required

Adjust side-brush lowering

Replace side brush

Lower the side brushes

Check the drive belt of the side brush

Inform Kärcher Customer Service.

Check Bowden cable of the side-brush raising

Inform Kärcher Customer Service.

Correct the setting of the sweep track; for this, engage both adjustment levers into the upper boring

(1...3)