Building In; Connection To The Power Supply System - KKT KOLBE EBMS4503S Benutzerhandbuch

Installation

Building in

Do not hold or carry the appliance by the door
!
handle. The door handle cannot hold the weight
of the appliance and may break off.
• Carefully slide the appliance into the installation niche
and align it centrally.
• Make sure that the connection cable is not bent, crus-
hed or damaged.
525

Connection to the power supply system

!
Important information
• The appliance is equipped with a power cord whose
plug may only be connected to a properly installed
and grounded power outlet.
• The mains voltage indicated on the rating plate
must correspond to that of your home.
• A socket may only be installed by a qualified electri-
cian in accordance with the applicable regulations.
• If the plug is no longer accessible after installation,
an all-pole disconnector with a contact gap of
at least 3 mm must be installed.
• Open the appliance door and secure the appliance
to the built-in unit by manually screwing the enclosed
screws into the openings on the side of the cooking
chamber. Be careful not to overtighten them.
• The gap between the worktop and the appliance must
not be covered by addtional battens.
• Do not trap or bend the power cable.
• Contact protection must be guaranteed by the installa-
tion.
• Do not use adapters, multiple sockets or
extension cables.
Overloading can lead to a fire hazard.
Illustration may vary
61