Installation
Building in
• Do not hold or carry the appliance by the door handle. The door handle cannot hold the
!
weight of the appliance and may break off.
Steps
!
1. Carefully push the oven into the box, making sure
that it is in the centre.
2. Open the door and fasten thewith the screws that
were supplied.
!
Important Information
Electrical connection
The appliance is fitted with a plug and must only be connected to a properly
installed earthed socket.
Only a qualified electrician who takes the approriate regulations into account
may install the socket or replace the connecting cable. If the plug is no longer
accessible following installation, an all-pole isolating switch must be present
on the installation side with a contact gap of at least 3 mm. Contact protection
must be ensured by the installation.
Fuse protection: see instructions for use-technical data.
70
• Fully insert the appliance and centre it.
• Do not kink the connecting cable.
• The gap between the worktop and the appliance
must not be closed by addtional battens.