Maintenance And Faults; Decommissioning And Disposal - eder Titan 80 Pro Bedienungsanleitung

53 Titan 80 Pro, Funk Titan 80, Titan 50

Maintenance and faults

Check the spring steel plates regularly for damage. If cracks or angular
material deformations appear, replace them immediately.
Check the operation of the felling wedge regularly. To do this, clamp the
housing in a vice and unscrew the wedge as far as it will go. If the
movement of the wedge is stiff, the drive nut must be replaced. The shaft
should turn softly and easily.
In the event of a malfunction, have the device checked by the
manufacturer, a certified workshop or the dealer.
Only use technically flawless original accessories and spare parts.
Only use technically flawless original accessories and
i
spare parts.
In case of malfunction of the radio Titan 80 - see table in chapter Control
of the radio felling wedge.

Decommissioning and disposal

If the welling wedge is no longer serviceable and is to be scrapped, you
must deactivate and dismantle it, i.e., you must bring the device into a
condition in which it can no longer be used for the purposes for which it
was designed.
The manufacturing company declines all responsibility
i
for any personal injury or damage to property resulting
from the reuse of tool parts if these parts are used for a
purpose other than the original material purpose.
EN
309001_00 | 03.2023