Before Use; Charging The Product; Use; Using The Product Disconnected From A Power Supply - Parkside PATC 2 B1 Bedienungs- Und Sicherheitshinweise

WEAR PROTECTIVE GLOVES! Leaked or damaged
batteries / rechargeable batteries can cause burns on
contact with the skin. Wear suitable protective gloves
at all times if such an event occurs.
This product has a built-in rechargeable battery which cannot
be replaced by the user. The removal or replacement of the re-
chargeable battery may only be carried out by the manufacturer
or his customer service or by a similarly qualified person in order
to avoid hazards. When disposing of the product, it should be
noted that this product contains a rechargeable battery.

Before use

Charging the product

Note: Remove all packaging materials from the product.
Note: You can recharge the product using a normal household socket.
Note: To use the product without an adapter, you must first charge the
integral rechargeable battery. It takes 5–7 hours to charge the inte-
gral batteries. The rechargeable battery is permanently installed in
the handle of the product.
Note: Charge the product for approximately 12 hours before first use.
Note: Charge the product at least once a month, if it is to remain
unused for an extended period of time.
Only connect the product to a properly installed USB socket by SELV
adaptor with max. 5 V
Note: If the product has not been charged for an extended period
of time (approx. 2 months), you could find that the integral recharge-
able battery has entered a dormant state. Charge and discharge the
product a number of times in succession to reactivate the integral
rechargeable battery.
Insert the USB connector of the USB cable
socket of the product.
Then insert the USB plug of the USB cable
on USB power supply.
Note: The product has an overcharging protection system. Never-
theless, you should disconnect the product from the mains once the
charging process is complete.
Note: The charging indicator
process. When the charging process is complete, the charging indicator
illuminates green.
5

Use

CAUTION – RISK OF ACCIDENT! If at all possible, do not use
the product in a moving vehicle. If the product is used in a vehicle, it
must not be allowed to endanger the safety of the driver or passengers.
Always store and secure the product in such a way that there is no
risk of injury from or damage to the product, even during full braking.
Note: You can secure the product by using the hook
netic base on a flat, ferromagnetic surface. Use the joint
4
the product up to approx. 180° on the magnetic base
light can be rotated to a desired angle.
2
CAUTION! Please note the position of your hands whilst turning the
magnetic holder to prevent pinching your fingers (see Fig. C).
Using the product disconnected
from a power supply
Fully charge the product, as described in the section on
"Charging the product".
The product can be operated in 3 different modes, select these
by repeatedly pressing the ON / OFF switch
(Uout) 500 mA.
illuminates red during the charging
5
into the USB input
8
into the USB port
8
or the mag-
1
to tilt
7
. The strip
4
.
3
GB/IE 15