Before Use; Charging The Product; Checking The Battery Capacity - Parkside PBSL 5000 B1 Bedienungs- Und Sicherheitshinweise

This product has a built-in rechargeable
battery which cannot be replaced by the
user . The removal or replacement of the
rechargeable battery may only be carried out
by the manufacturer or his customer service
or by a similarly qualified person in order
to avoid hazards . When disposing of the
product, it should be noted that this product
contains a rechargeable battery .
˜ Before use
˜ Charging the product
NOTES:
Remove all packaging materials from the
product .
In order to use the product without a
USB cable , you need to recharge
[ 10 ]
the rechargeable battery before use . The
charging process takes about 6 .5 hours . The
rechargeable battery is firmly integrated into
the base of the product .
Fully charge the rechargeable battery prior
to first use .
Charge the battery if it becomes empty
(only 1 LED of the charging indicator
flashing) .
Open the protective cap
Connect the USB plug of the USB cable
to the USB input socket
NOTES:
The battery charging status is shown by the
charging indicator
Charging indicator
status
1 LED flashes
1 LED lights up, 1 LED flashes
2 LEDs light up, 1 LED flashes
3 LEDs light up
The charging time is approximately 6 .5 hours
when the battery was drained .
is
6 ] [
.
7 ] [
[ 10 ]
on the product .
8 ] [
:
6 ] [
Battery
[ 6 ]
charging
status
0‒33 %
34‒65 %
66‒99 %
100 %
NOTE: The product has an overcharging
protection system . Nevertheless, you should
disconnect the product from the mains once the
charging process is complete .
Disconnect the USB cable
product to prevent the batteries discharging
themselves .
Close the protective cap
to use the product again . Otherwise water
could enter to the product when it is used
outdoors .
The product is not working at temperatures
below +5 °C and above +45 °C due to its
battery protection .
˜ Checking the battery capacity
When product is not charged: Press the ON/OFF
switch to check the battery capacity . The red
[ 2 ]
charging indicator shows the capacity* of the
[ 6 ]
battery inside the product .
1 LED lights up = 33 %*
2 LEDs light up = 66 %*
3 LEDs light up = 100 %*
* This is the approximate percentage of battery
capacity but not actual measurement .
˜ Mounting the product
Each of the adjustable 2 foot / hand grips
is equipped with 4 magnets
magnets, the product can be attached to
magnetisable surfaces .
m
CAUTION! A single adjustable foot /
handle grip is not sufficient for attaching
4 ] [
the product to magnetisable surfaces (Fig . E) .
from the
10 ] [
before you start
7 ] [
4 ] [
. With these
5 ] [
GB/IE 19