Before Use; Charging The Product - Parkside PSDD 2000 A1 Bedienungs- Und Sicherheitshinweise

with the chemicals! Flush immediately the affected ar-
eas with fresh water and seek medical attention!
skin. Wear suitable protective gloves at all times if
such an event occurs.
This product has a built-in rechargeable battery which
cannot be replaced by the user. The removal or re-
placement of the rechargeable battery may only be
carried out by the manufacturer or his customer service
or by a similarly qualified person in order to avoid
hazards. When disposing of the product, it should be
noted that this product contains a rechargeable battery.

Before use

Charging the product

Note: Remove all packaging materials from the product.
Note: The product must be connected to an AC adapter
or to a computer. The technical data of these devices (not
included in the scope of delivery) must be observed.
Note: In order to use the product without a USB cable
you need to recharge the rechargeable battery before use.
The charging process takes about 4 to 5 hours. The recharge-
able battery is firmly integrated into the base of the product.
Note: Charge the product for approx. 12 hours prior to
first use.
Open the protective cap and connect the USB cable
with a computer or with the USB connector of a power
adapter.
Connect the type-C-USB connector on the USB cable
to the type-C-USB input socket
Plug the power adapter into a socket.
Note: The battery charging status is shown by the charg-
ing indicator
Charging indicator
status
1 LED flashes
1 LED lights up, 1 LED
flashes
10 GB
WEAR PROTECTIVE GLOVES! Leaked
or damaged batteries / rechargeable bat-
teries can cause burns on contact with the
:
1
1
on the product.
5
Battery charging
status
0–25 %
25–50 %
,
10
10
10