Other Risks - Scheppach Ke 70m Anleitung

• Workpieces must be completely free of foreign ob-
jects, i.e. nails or screws.
• The machine must only be used in technically per-
fect condition in accordance with its designated
use and the instructions set out in the operating
manual, and only by safety-conscious persons who
are fully aware of the risks involved in operating
the machine. Any functional disorders, especially
those affecting the safety of the machine, should
therefore be rectified immediately.
• The manufacturer's safety instructions, operating
instructions and maintenance instructions as well
as the dimensions given in the technical data must
be observed.
• The applicable accident prevention regulations
and other generally accepted safety regulations
must be complied with.
• The machine may only be used, maintained, and
operated by persons familiar with it and instructed
in its operation and procedures. Arbitrary altera-
tions to the machine release the manufacturer from
all responsibility for any resulting damages.
• The machine may only be used with original ac-
cessories and original tools made by the manu-
facturer.
• Any other use exceeds authorization. The manu-
facturer is not responsible for any damages result-
ing from unauthorized use; risk is the sole
responsibility of the operator.
• Only use saw blades that comply with the Euro-
pean standard DIN EN 847-1.
• Ensure adequate lighting.
• Make sure that the machine is secure on the ground
when installing the machine.
• The area around the machine must be free of trip
hazards.
• The machine may only be operated outdoors with-
out exhaust.
Attention: risk of accident!
The wood must always be seated on both sides of the saw blade on the v-block of the rocker. (see arrows).
Caution Danger of accidents!
Wear safety shoes.
Accident risk!
Before commissioning instruction
manual read.
20 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
4. m Other risks
The machine has been built using modern tech-
nology in accordance with recognized safety
rules. Some remaining hazards, however, may
still exist.
• The rotating saw blade can cause injuries to fingers
and hands if the work piece is incorrectly fed.
• Danger to health from wood dusts or wood chips.
• Always wear personal protective equipment such
as eye protection and dust mask.
• Noise can be a health hazard. The permitted noise
level is exceeded when working. Be sure to wear
personal protective gear such as ear protection.
• Hazardous current, when using improper electrical
connections.
• Even when all safety measures are taken, some
remaining hazards which are not yet evident may
still be present.
• Remaining hazards can be minimized by following
the instructions in "Safety Precautions", "Proper
Use" and in the entire operating manual.
• Defective saw blades can cause injuries. Regularly
inspect the structural integrity of saw blades.
• The operating instructions supplied with the special
accessories must be observed and carefully read
when Scheppach special accessories are used.
Caution Danger of accidents!
To wear ear protection.
Wear safety glasses.
Attention!
Tool continues to run after
power disconnected!
Before any maintenance, cleaning
or repair work, disconnect the unit
from the power supply!