Use Only As Authorized; Other Risks - Scheppach HS520 Original Bedienungsanleitung

3. Use only as authorized

The firewood circular saw is designed exclu-
sively with the offered tool for the processing
of wood.
The machine corresponds to the valid EC guide-
line.
• The log saw is constructed as 1-man-operating
stand and is only to be used in outdoor locations.
• The machine is designed for single-shift operation,
switch-on duration S6 - 40%
• The log saw is a portable circular saw. It is only ap-
plicable to cross cut firewood with a feeding rocker
according to the technical specifications.
• The saw is constructed solely for cross cutting of
firewood with max. 1,2 meter length.
• Regardless of the diameter of the wood only 1
work piece is to be put on the rocker.
• Observe all safety and hazard notes on the ma-
chine and ensure they are kept complete and in a
legible condition.
• The machining range and surrounding areas of the
machine must be clear of interfering foreign matter
to prevent accidents occurring.
• Workpieces must be completely free of foreign ob-
jects, i.e. nails or screws.
• The machine must only be used in technically per-
fect condition in accordance with its designated
use and the instructions set out in the operating
manual, and only by safety-conscious persons who
are fully aware of the risks involved in operating
the machine. Any functional disorders, especially
those affecting the safety of the machine, should
therefore be rectified immediately.
• The manufacturer's safety instructions, operating
instructions and maintenance instructions as well
as the dimensions given in the technical data must
be observed.
• The applicable accident prevention regulations
and other generally accepted safety regulations
must be complied with.
• The machine may only be used, maintained, and
operated by persons familiar with it and instructed
in its operation and procedures. Arbitrary altera-
tions to the machine release the manufacturer from
all responsibility for any resulting damages.
• The machine may only be used with original acces-
sories and original tools made by the manufacturer.
• Any other use exceeds authorization. The manu-
facturer is not responsible for any damages result-
ing from unauthorized use; risk is the sole
responsibility of the operator.
• Only use saw blades that comply with the Euro-
pean standard DIN EN 847-1.
• Ensure adequate lighting.
• Make sure that the machine is secure on the ground
when installing the machine.
• The area around the machine must be free of trip
hazards.
• The machine may only be operated outdoors with-
out exhaust.
26 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

4. Other risks

The machine has been built using modern tech-
nology in accordance with recognized safety
rules. Some remaining hazards, however, may
still exist.
• The rotating saw blade can cause injuries to fingers
and hands if the work piece is incorrectly fed.
• Danger to health from wood dusts or wood chips.
Always wear personal protective equipment such
as eye protection and dust mask.
• Noise can be a health hazard. The permitted noise
level is exceeded when working. Be sure to wear
personal protective gear such as ear protection.
• Hazardous current, when using improper electrical
connections.
• Even when all safety measures are taken, some
remaining hazards which are not yet evident may
still be present.
• Remaining hazards can be minimized by following
the instructions in "Safety Precautions", "Proper
Use" and in the entire operating manual.
• Defective saw blades can cause injuries. Regularly
inspect the structural integrity of saw blades.
• The operating instructions supplied with the special
accessories must be observed and carefully read
when Scheppach special accessories are used.