Saw Blade Change Of Roll Table Circular Saw - Scheppach Ke 70m Anleitung

The intervals mentioned herein are based on normal conditions of use. An excessive use of the machine shortens the
intervals accordingly.
Clean the panels, screens and control levers with a soft cloth. The cloth should be dry or slightly humid with a neutral
cleaning agent. Do not use any solvents like alcohol or benzene as they could damage the surfaces.
Keep oils and lubricants out of reach of unauthorised persons. Read through the instructions on the containers carefully
and follow them closely. Avoid direct contact with the skin and wash off thoroughly after use.
m Check all safety devices after maintenance and cleaning work.
Maintenance
Turn the engine off and let the engine cool down. Re-fit the mains plug.
Check the general condition of the machine. Be careful with loose screws, misaligned or moving parts, breakage of
parts, and any other condition that could interfere with safe operation.
Remove any foreign objects and other materials that have accumulated on the saw blade and the unit. Clean the
machine after each use. Then use a high-quality and thin fluid machine oil to lubricate all moving parts.
m Never use a "pressure washer" to clean your unit. Water can penetrate tight areas of the machine and its
transmission case and cause damage to spindles, gears, bearings, or the engine. The use of pressure washers
will result in shortened life and reduce serviceability.
Experienced craftsmen can perform minor repairs on the machine itself.
• Check the saw blade regularly. Use only well-sharpened, crack-free and not distorted saws. Use only tools that
comply with the European standard EN 847-1.
• Exchange immediately rocker that run out.
• Check all safety installations after each maintenance and cleaning activities.
• Ensure that there are no tools or other materials on or in the machine before putting it into operation.
• Remove possible sawdust blockages at the discharge.
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts
are therefore also required for use as consumables.
Wear parts*: sawblade, Table insert, saw blade protection insert
* Not necessarily included in the scope of delivery!

16. Saw blade change of roll table circular saw

Wait until stationary and allow to cool down!
Attention! Remove the mains plug!
The saw blade can only be changed when the table is folded up and is carried out in the following steps:
The protective basket must always be closed.
1 Unlock table stop (E).(Fig. 1)
Fig. 1
E
26 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58