Handling The Protection Cage; Sawing Operation; Maintenance And Service - Scheppach Ke 70m Anleitung

13. Handling the protection cage

A
A
B

14. Sawing operation

m Attention! The protective basket can only be opened in its original position.
1 After the machine has been switched on, wait until the saw blade has reached full speed.
2 Open the protective cover
3 Place the material to be cut on the saw table.
4 Close the protective basket and guide the table to the saw blade in an even manner.
5 Only apply enough pressure when sawing so that the speed of the saw blade does not drop.
6 Remove the sawn wood from the saw table after it has returned to its original position and the saw blade is covered.
m Attention!
• Do not leave the machine unattended during operation.
• Turn off the machine when not working and pull the mains plug.
End of work
• Switch off the drive motor with the On/Off switch.
• Wait until the blade has completely stopped.
• Unplug the power cord or the spark plug connector.
• Observe general maintenance instructions.
• Bring the table to the transport position and secure it with the locking screw.

15. Maintenance and service

m Perform maintenance, modification, adjustment and cleaning work only with the engine switched off and the
mains plug or spark plug connector is unplugged.
• Keep the manual at the machine.
• Keep machine clean.
• Wear protective goggles when cleaning.
Before undertaking any maintenance or checking work, the working area must be cleaned. Keep the necessary tools
within the reach of your hand.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Open the protective cover (A).
• Insert the material to be cut (B).
• Close the protective cover (A).
• Fix the material to be cut (B) with a handle (C).
• Slide table (D) to the saw blade and saw through the material
to be cut.
• Return the table and open the protective basket.
• Add more material to be cut (B) and close the protective
basket (A) again.
C
D
GB 25