Cameo FLAT PRO INDOOR PAR CAN Bedienungsanleitung Seite 10

OPERATION:
NOTE:
When the projector is properly connected to the mains, the following information
appears successively in the display during the startup process: "Software Update,
Please Wait..." (for service purposes only), the software version "Software V1.xx"
and "WELCOME TO cameo". After this operation, the projector is ready for use and
changes to the mode that was previously selected.
STATIC COLOUR
This mode offers the ability to separately adjust the intensity for each of
the 5 LED groups and to generate an unlimited number of different colours
(colour mixing).
Press the MODE button until "STATIC" appears in the upper line of the
display. By repeatedly pressing the ENTER button, select the LED group
for which you want to change the brightness level (please note the cursor
in the display, Rxx = red, Gxx = green, Bxx = blue, Wxx = white, Axx =
amber). Now you can set the intensity of the selected light from 00 to 99
using the UP and DOWN buttons (example: R00 = red at 0%, i.e. out. R99 =
red at 100%, i.e. maximum brightness).
Adjust the flash frequency of the strobe effect by pressing ENTER repea-
tedly until the cursor shows "Fxx". Now you can activate the strobe effect
using the UP and DOWN buttons and set the flash frequency from 00 to 99
(F00 = strobe effect deactivated, F01 = approx. 1 Hz, F99 = approx. 20 Hz).
Confirm with ENTER.
RED
Intensity R00 - R99
GREEN
Intensity G00 - G99
BLUE
Intensity B00 - B99
WHITE
Intensity W00 - W99
AMBER
Intensity A00 - A99
STROBOSCOPE
Speed F00 - F99
10