Manual Mode; Auto Mode; Slave Mode - Cameo THUNDERWASH 600 UV Bedienungsanleitung

CONFIGURE DMX START ADDRESS
Press the MODE button until the currently activated DMX start address is displayed (A001–A512) and press ENTER (the characters in the
display will flash). The DMX start address can now be adjusted as desired with the UP and DOWN buttons. Confirm with ENTER. Synchro-
nous control of several lamps of the same model with a DMX controller (e.g. DMX console) can be achieved by configuring the lights with
the same DMX mode and the same DMX start address and connecting them via DMX cables.
ENTER
/
UP/DOWN

MANUAL MODE

The manual mode allows you to adjust the brightness of the UV LEDs and activate a strobe effect. Press the MODE button repeatedly until
"C000" appears in the display. Now press ENTER then use the UP and DOWN buttons to select either the menu item "C1xx" for brightness,
or the menu item "CFxx" to configure the strobe effect. When you have selected a menu item, press ENTER again and you can now use the
UP and DOWN buttons to set the value as required for brightness or for the stroboscopic effect (see table). Confirm your entry with ENTER.
Manual mode
C100 Blackout
C101 minimum brightness
C199 maximum brightness
CF00 Strobe disabled
CF01 Strobe approx. 1 Hz
CF99 Strobe approx. 30 Hz
FADING MODE
Gentle fading the UV LEDs in and out from blackout to maximum brightness and back to blackout at an adjustable speed. A strobe effect can
also be activated. Press the MODE button repeatedly until "FA00" appears in the display. Press ENTER then use the UP and DOWN buttons
to select either the menu item "FAxx" for the fade speed, or the menu item "FFxx" to configure the strobe effect. When you have selected
a menu item, press ENTER again to be able to use the UP and DOWN buttons to set the value as required for the fading speed or for the
stroboscopic effect (see table). Confirm your entry with ENTER.
Fading mode
FA00 minimum fade speed
FA99 maximum fade speed
FF00 Strobe disabled
FF01 Strobe approx. 1 Hz
FF99 Strobe approx. 30 Hz

AUTO MODE

The Auto mode combines the fading mode with a strobe effect, whereby this is activated and deactivated at regular intervals. Press the
MODE button until "AUTO" is shown in the display, then press ENTER to use the UP and DOWN buttons to set the effect speed as required.
Confirm with ENTER.
Auto mode
AU00 minimum effect speed
AU99 maximum effect speed

SLAVE MODE

Press the MODE button repeatedly until "SLAV" appears in the display. Connect the slave and the master units (same model) with a DMX
cable and enable one of the standalone modes on the master unit (manual mode, auto, fading mode, sound-control). Now the slave unit will
follow the master unit.
6
ENTER