Reading The Display; Acoustic Signals - struers TegraPol-11 Gebrauchsanweisung

Reading the Display

Acoustic signals

10
TegraPol-11/ -15
TegraForce-1
Instruction Manual
The display on the front panel provides different levels of status
information. For example, when the machine is switched on using the
Mains switch located at the rear of the machine, the display informs
you about the physical configuration of the TegraPol and the version
of software that is installed:
When operating the TegraPol, this display is the user-interface to
TegraPol's software.
The display is primarily divided into 2 areas. The position of these
areas and the information they contain are explained in the
illustration below, which uses the CONFIGURATION Menu as an
example:
Heading: this is a navigational aid, telling you where you are in
A
the software's hierarchy.
Information fields: these will either be numerical values or text
B
fields providing information associated with the process shown in
the heading. The inverted text shows the cursor position.
When pressing a key, a short beep indicates that the command has
been accepted, whereas a long beep indicates that the key cannot
be activated at the moment.
A
B