Connecting A Recirculation Cooling Unit; Connecting The Water Inlet; Connecting The Water Outlet; Connecting The Communication Cable - struers TegraPol-11 Gebrauchsanweisung

Connecting a Recirculation
Cooling Unit

Connecting the Water Inlet

A

Connecting the Water Outlet

B
Connecting the Communication
Cable
TegraPol-11/ -15
TegraForce-1
Instruction Manual
To ensure optimal cooling, TegraPol can be fitted with a Struers
Recirculation Cooling Unit.
The Recirculation Cooling Unit cannot be used with TegraPol units running
methods that include the dosing of oxide polishing suspensions.
Before connecting the cooling unit to the TegraPol,
follow the instructions in the Struers Cooling Units Instruction Manual
 Take the inlet hose delivered with TegraPol and cut off the
coupling nut on the straight end.
 Slide the hose clamp onto the hose and insert the quick coupling
delivered with the pump for the recirculation cooling unit. Tighten
the hose clamp.
 Connect the quick coupling on the inlet hose directly to the cooling
unit's pump outlet (A).
If necessary, use one of the hoses delivered with the pump to
extend the inlet hose.
 Mount the other end to the water inlet tube.
 Mount the outlet hose onto the water outlet tube. Use a hose
clamp to secure the hose.
If there is only limited space behind the TegraPol, use the pipe
bend and attach it directly to the outlet tube on the back of the
TegraPol. Then attach the drain hose to the other end of this
bend.
 Lead the other end into the mounting hole in the bracket on top of
the static filter unit (B). Arrange the tube so that it slopes
downward towards the drain throughout its length. Shorten the
hose, if necessary.
 Connect the communication cable to the Cooli Control Box and
then connect to the socket 1 at the rear of the TegraPol.
Before connecting, check that the mains voltage corresponds to the voltage
stated on the type plate on the side of the machine.
Please note:
Note
to prepare it for use.
IMPORTANT
7