Danger Of Injury; Hot Surface; Installation; Preparing The Installation - Wilo Stratos PARA-C Einbau- Und Betriebsanleitung

DANGER
Risk of fatal electrical shock! Generator or turbine operation during
pump flow!
Even without the module (without electrical connection), there may be dangerous contact
voltage at the motor contacts.
• Avoid flow in the pump during dismantling/installation work!
• Close the existing shut-off devices in front of and behind the pump!
• If no shut-off devices are fitted, drain the system!
WARNING

Danger of injury!

Only carry out work on the pump/system using suitable tools and once it has come to a
standstill.
WARNING

Hot surface!

The entire pump can become very hot. There is a risk of burns!
• Allow the pump to cool down before commencing any work!
7.1

Installation

7.1.1 Preparing the installation

May only be installed by qualified installers.
Observe the following points before installation:
Installation within a building:
• Install the pump in a dry, well-ventilated, frost-free room.
Installation outside a building (outdoor installation):
• Install the pump in a chamber with cover or in a cabinet/housing as weather protection.
• Avoid exposure of the pump to direct sunlight.
• Protect the pump against rain.
• Keep the motor and electronics continually ventilated to avoid overheating.
• The permitted fluid temperatures and ambient temperatures should not be exceeded or undershot.
• Choose an installation point that is easily accessible.
• Observe the pump's permitted installation position (Fig. II).
Installation and operating instructions • Wilo-Stratos PARA-C/-CZ • Ed.01/2023-04
en
51