Hitachi NV 65AD3 Bedienungsanleitung Seite 5

Adjust the position of the nail holder according to the
length of the nail. Clamp and raise the nail holder with
two fingers and turn it to align the mark with the
numbers (65, 57, 50) (Fig. 1).
For 50
For 65, 57
Cover
Nail Holder
Load the nails in the magazine. Insert the beginning of
the nail into the opening of the magazine to facilitate
the following procedures (Fig. 2).
Magazine
Cover
First Nail
Close the cover after confirming that the nails are
loaded in the magazine.
NOTE:
Before loading the nails in the magazine, position the
nail holder according to the length of the nail. If the nail
holder position is not adjusted, the nail jam. If the
cover is forcibly closed without adjusting the position
of the nail holder, the nail holder may be damaged.
(2) Load nails in the guide
Greip the nail guide and knob with fingers. Then
depress the knob to open the nail guide towards
the left. (See Fig. 3)
Mark
Fig. 1
Magazine
Opening
Nail
Fig. 2
Knob
Nail Guide
Extend the nail line from the magazine.
When using wire collated nails
Insert the first nail into the driving hole and the second
nail between the two pawls of the feeder. Insert the
nail so that the nails head engages the guide slot. (Fig.
4)
First Nail
Nail Guide
Nail outlet
When using plastic collated nails
Insert the first nail between the pawls of the feeder.
Insert the nail so that the nail head engages the guide
slot. (Fig. 5)
NOTE:
Be careful not to insert the first nail in front of the pawl
of the feeder as this can cause jamming of nails.
First Nail
Nail Guide
English
Magazine
Opening
First Nail
Fig. 3
Feeder
Guide Slot
Guide Surface
Feeder
Fig. 4
Feeder
Guide Slot
Feeder
Fig. 5
4