Protection Against Overheating; Assembly; Transport - Silvercrest SLE 200 B2 Kurzanleitung

Protection against overheating

The appliance has an overheating protection. It switches off automatically if
there is a risk of overheating and switches back on once the appliance has fully
cooled down. The appliance cannot be used during the cool-down phase.
♦ Check whether external conditions may have triggered the overheating
protection (e.g. temperatures above 32°C or a blockage to the air
outlet 8).

Assembly

WARNING! – RISK OF INJURY!
► Do not connect the appliance to a power socket during assembly.
♦ Lay the appliance flat on its side on the floor.
♦ Press the castors 6 into the four holes on the bottom of the appliance
until they fully click into place (see fig. 1).
Fig. 1
♦ Place the appliance on the castors 6 after fitting them.

Transport

CAUTION! PROPERTY DAMAGE!
► Never pull the appliance by the power cable w when transporting it on
its castors 6.
► Use the castors 6 only on even surfaces. Do not roll the appliance over
shag-pile carpets (e.g. flokati, tufted). These could block the castors 6
♦ Use the castors 6 to move the appliance over even surfaces.
♦ Always hold the appliance by the carrying handle 7 when transporting it.
■ 12 │ GB │ IE
.
SLE 200 B2