Lighting - hanseatic SY-103E9G-P1-C13-L22-600 Gebrauchsanleitung

4. Only when replacing:
The two charcoal filters (16) are located to
the right and left of the motor (17).
Loosen the two charcoal filters and remo-
ve them.
5. Place the new charcoal filters to the right
and left of the motor and tighten them in
an anti-clockwise direction. Allow the lock
to click into place.
6. Place the grease filter (15) with the pins
into the openings.
Care and maintenance
7. Push the lock (14) to the side; snap the
grease filter (15) shut and release the lock
again.
8. Close the cover (13) again and allow it to
click into place.
The exhaust hood is now mounted to the
wall.
9. Switch the power back on.
10. Dispose of the used charcoal filters with
household waste.

Lighting

WARNING
Risk of injury!
Touching live parts may result in severe
injury or death.
■ If one of the LEDs ceases to work, it
must be changed by an authorised
service technician.
The light source is exchangeable and may
only be exchanged by an authorized speci-
alist!
(13)
Note for the service technician: This exhaust
hood requires LEDs with the ILCOS D-Code
DBR-2/65-H-64 110–240 V~, 2W.
(14)
(15)
Page EN-11