Operating Instructions; Making Bags From Magic Vac Rolls; Vacuum Packing With Bags Cut From A Roll Or Pre-Cut Bags; Vacuum Packing In Magic Vac - Magic Vac Prestige Roll Betriebsanleitung

Prestige Roll Ing. New
Warning: DO NOT LEAVE THE LID WITH LOCKS ENGAGED WHEN THE UNIT IS NOT IN USE.
Before use, always thoroughly clean your appliance
and any accessories coming in contact with food
(containers, caps, jars etc.) as directed in the
"INSTRUCTIONS FOR CLEANING" paragraph.
1 Positioning the appliance
Position the appliance in a dry place on a level surface,
making sure that the work area in front of the
appliance itself is clear of obstacles and there is
enough room to accommodate the bags with the food
to be packed. Plug the power cord into a power socket
corresponding to the voltage of the appliance (see
technical details).
2 Tips on using bags

MAGIC VAC

® bags are available in two widths: 20 and
30 cm. Choose the bag size suited for the food you
intend to preserve. Check that the bag you are going to
use is at least 8 cm longer than the food to be
packaged, taking into account an additional 2 cm for
each time the bag will be subsequently reused.
Note: If you are using pre-cut bags, go directly to step
4 below.
3 Making bags from MAGIC VAC
- Lift the roll holder compartment lid (3), insert the bag
roll (fig. A) leaving an end outside to draw the bag
out and close the lid.
Warning: Each time you close the Roll compartment
lid, make sure that the Bag cutter is positioned at one
end of the slot it slides along. The bag cutter MUST
NOT BE IN THE MIDDLE of the lid!
- Unroll a bag of suitable length (fig. B). Press the bag
cutter blade (7) starting from either side of the bag
and slide it for the necessary distance according to
width. In this way you will cleanly and precisely cut
a piece (fig. C). Now you can seal an open side of the
cut bag as follows:
- Lift the lid (4) and turn it in the open position.
- Seal either of the two open ends of the bag by
positioning it on the sealing gasket (8) with the
smooth side facing down (fig. D).
Warning: be careful not to let the bag hang over into
the vacuum chamber (11) or on the sealing gasket (12).
- Close the lid (4) and push down on the front corners
of the lid with your thumbs, then push the LOCK
buttons (9) into the locked position (fig. E). The
appliance will automatically carry out the complete
vacuum packing cycle. Wait until the ON/SEAL light
goes off (1).
- Press down on the rounded recessed area of the
manual valve (5) to release the lid (fig. F).
- Lift the appliance lid putting the fingers under the
central projecting part and remove the bag.
- Check the quality of the seal obtained, which should
appear as a regular, wrinkle-free crosswise strip
with no internal ridges in the bag (fig. G). If the seal
is not complete repeat the packing cycle.
27-04-2010 15:38

OPERATING INSTRUCTIONS

® rolls
16
Pagina 3
4 Vacuum packing with bags cut from a roll or pre-
cut bags
- Lift the lid (4) and turn it in the open position.
- Place food in the bag without creasing it excessively
or stretching surfaces. Eliminate any liquids or food
residues from the area inside the bag that will be
sealed.
- Place the bag and its contents in front of the
appliance and place the open end inside the
vacuum chamber (11) with the smooth side facing
down (fig. H).
- Close the lid (4) and push down on the front corners
of the lid with your thumbs, then push the LOCK
buttons (9) into the locked position (fig. I). The
appliance will automatically carry out the complete
vacuum packing cycle. Wait until the ON/SEAL light
goes off (1).
- Press down on the rounded recessed area of the
manual valve (5) to release the lid (fig. L).
- Lift the appliance lid putting the fingers under the
central projecting part and remove the bag.
- Check the quality of the seal obtained, which should
appear as a regular, wrinkle-free crosswise strip
with no internal ridges in the bag. (fig. M) If the seal
is not complete repeat the packing cycle.
- The appliance can be stopped at any time by
pressing down the manual valve (5). The appliance
stops only when the lid ( ( 4 4 ) ) is raised.
5 How to use the MAN SEAL button (2)
Pressing this button causes the SEAL light (1) to go on
and the sealing process starts immediately. This allows
you to prevent delicate, fragile foods from being
crushed (e.g. biscuits, etc.) (fig. N).

6 Vacuum packing in MAGIC VAC

containers or in containers sealed with MAGIC
VAC ® Universal Caps with new knob
MAGIC VAC Executive containers and the MAGIC
®
VAC ® Universal Caps with star-shaped knob (see fig. O)
make vacuum packing easier, because the connection
hose can be directly introduced into the knob central
hole (see fig. P).
MAGIC VAC ® Universal Caps, available in two
diameters (100 mm and 125 mm), are to be used on jars
for preserving food and bowls and receptacles made
of tempered glass. The Universal Caps work just like
Executive
the Caps for MAGIC VAC ®
WARNING: When using Universal Caps do not use
plastic or glass containers that are not suitable since
they could implode under the vacuum pressure of the
appliance and cause injury.
- Fill the container leaving at least 3 cm of room
between the contents and upper rim. Place the lid
on the container and turn the knob to the "VACUUM"
position (fig. O).
- Connect the container lid knob to the appliance air
inlet (6) by means of the connection hose (15) (fig. P).
- Lock the lid (4) by pushing the LOCK buttons (9); the
machine will carry out a vacuum packing cycle and
® Executive
containers.