Troubleshooting - Magic Vac Prestige Roll Betriebsanleitung

Prestige Roll Ing. New
The MAGIC VAC ® does not work
• Make sure the MAGIC VAC
in properly. Check the electric socket by
plugging another appliance into it.
• The MAGIC VAC ®
overheated. Allow it to cool down for 15 minutes
and try again.
• Check for faults in the power cord or the plug.
Should you detect a fault, do not use the
appliance.
The MAGIC VAC ® fails to apply the first seal on
the bag cut from the roll
• Make sure the bag cut from the roll is properly
positioned as described in the paragraph:
"Making bags from MAGIC VAC
The MAGIC VAC ® does not create a complete
vacuum in the bags
• To seal the bag properly, you must make sure
that the open end remains completely inside the
Vacuum Chamber.
• Make sure that the Sealing Bar, the Sealing
Gaskets and Airtight Gaskets are free of
impurities. After cleaning them, put them
properly back in place.
• The MAGIC VAC ®
check it, seal the bag with air on the inside. Dip
the bag in water and apply pressure. The
appearance of bubbles means that there is a
leak. Reseal or use another bag.
The MAGIC VAC does not seal the bag properly
®
• If the Sealing Bar overheats and melts the bag,
you may have to raise the Lid and allow the
Sealing Bar to cool down for a few minutes.
• The MAGIC VAC ®
current safety standards. Overheating will
cause it to turn off automatically. Allow the
appliance to cool down for 15 minutes and try
again.
The MAGIC VAC bag does not maintain a vacuum
®
after being sealed
• Leaks along the seam may be caused by
creases, crumbs, grease or liquids. Reopen the
bag, clean the upper inside part of the bag and
remove any foreign material from the Sealing
Bar before resealing it.
• Check the seal after each cycle; if it is not
complete, repeat the packing cycle.
• Check that the bag has no holes in it which have
caused air to leak in. Use paper napkins to
protect any sharp edges on the contents of the
bag.
27-04-2010 15:38

TROUBLESHOOTING

® has been plugged
will stop automatically if
rolls"
®
bag might have a hole in it. To
is built in conformity with
Pagina 6
The MAGIC VAC ® does not create a vacuum in the
containers
• By means of the Connection Hose, connect the
container lid (or the Cap Attachment if
necessary) to the Air Inlet of the appliance.
• Leave enough room (at least 3 cm) between the
contents and the top of the jar or container.
• If liquids come out during the vacuum-packing
process, remember that they must first be
chilled in a refrigerator, not left at room
temperature.
• Check that the rim of the jar or container and
the universal lid are not damaged in the sealing
area. Wipe the rim and cap clean with a cloth
moistened with lukewarm water and repeat the
vacuum-packing process.
• Make sure that the gasket of the container cap
or the universal cap is set properly in place and
is not damaged.
MAGIC VAC ® Executive containers or MAGIC
VAC ® Universal Caps do not maintain a vacuum
• Make sure that the arrow on the knob of the
container cap is positioned on "VACUUM" before
creating a vacuum in the container and it is
positioned on "CLOSED" after a vacuum is
formed.
• Make sure that the O-ring beneath the knob of
the container cap or the universal cap is set
properly in place.
Family containers do not maintain a
MAGIC VAC ®
vacuum
• Make sure that the gasket beneath the central
button (16) of the container cap is set properly in
place and is not damaged.
19