Scheppach XXL900 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 42

E2 Wheel motor blocked
E3 Cutter disc blocked
Obstacle sensor trigger not
E4
reset
E5 The mower was lifted
Roll-over sensor was trig-
E6
gered
Inclination sensors were
E7
triggered
E8 Docking/recharging failed
Rechargeable battery ther-
BP
mal protection
EE Error unknown
Robot mower locked (PIN
LOCK entered incorrectly too
many times)
• Switch the mower off. Move the mower to an area that is free of obsta-
cles. Press the "START" button and then the "OK" button.
• If the error message is still displayed, switch off the product. Turn the
mower upside down and check what is preventing the wheels from turn-
ing.
• Remove the objects blocking the wheel(s), turn the mower over.
• Then press the "START" and "OK" buttons.
• Switch the mower off.
• Turn the mower upside down and check what is preventing the blades
from turning.
• Remove the objects and turn the mower over.
• Place the mower in an area with short grass.
• Then press "START" and "OK".
• Contact your specialist dealer.
• Take the mower to a specialist dealer.
• Switch the mower off.
• Move the mower to an area that is free of obstacles. Press the "START"
button and then the "OK" button.
• If the error message is still displayed, switch off the product. Turn the
mower upside down and check if there is anything preventing the front
axle from moving.
• Remove all obstacles, turn the mower up the right way again and switch
it on. Press "START" and then "OK".
• Stand the mower upright.
• Press "START" and then "OK".
• Switch the mower off.
• Move the mower to an area in your lawn with level ground.
• Switch the mower on. Press "START" and then "OK".
• Check that there is 1 metre of space before and after the charging sta-
tion, without obstacles or corners.
• The charging station must be placed on level ground.
• Manually place the mower in the charging station for charging. After the
mower is fully charged, press "START" and then "OK".
• Switch the mower off.
• Move the mower to an area in your lawn with level ground.
• Check the temperature of the rechargeable battery.
• If the temperature is too high, let the rechargeable battery cool down.
• If the temperature is too low, wait until the temperature is higher than 5°C.
• Re-start the mower.
• If the error still occurs, replace the rechargeable battery.
• If the error still occurs, contact your specialist dealer.
• Re-start the mower.
• If the error still occurs, contact your specialist dealer.
• Wait 10 minutes and then enter the PIN again
• Do not switch the robot mower off
• If the error still occurs, contact your specialist dealer.
www.scheppach.com
GB | 35