Troubleshooting / Fault Codes; Fault Table; Possible Cause - Scheppach XXL900 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Information about collection points for old devices
can be found at your municipal authority, the local
disposal provider, an authorised location for the dis-
posal of old electrical and electronic devices or your
waste collection service.

15. Troubleshooting / fault codes

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.

15.1 Fault table

Fault
Mower does not start
LED light on charging station
does not light up
LED light on charging station
flashes red
Mower does not mow properly Blades are worn
Mower starts at unusual/
wrong times
Mower gets stuck
15.2 Fault codes
Error code Meaning
---- Rain sensor delay
Mower outside the working
E1
area
E11 No boundary signal
34 | GB

Possible cause

Mower or charging station not con-
nected to the mains
Boundary wire is not connected or
cut/broken.
Date/time is incorrectly set
Unsuitable terrain/obstacle
Remedy
• -
• Check that the mower is in the working area.
• Ensure that the charging station is properly connected to the charger
and the charging unit is connected to a suitable power supply. If proper-
ly connected, the boundary wires are incorrectly attached and must be
transposed.
• When the mower is in the working area, check the charging station LED
indicator. If it lights up red, make sure that the boundary wires are well
connected to the terminals on the charging station. If the problem per-
sists, check whether the boundary wires have been cut.
www.scheppach.com
Do not throw primary batteries or rechargeable
batteries away with household waste!
As a consumer, you are legally obliged to hand
in all batteries and rechargeable batteries, re-
gardless of whether they contain harmful sub-
stances* or not, to a collection point in your munici-
pality/district or to a retailer so that they can be
disposed of in an environmentally friendly manner.
*marked with: Cd = cadmium, Hg = mercury, Pb =
lead
Remedy
• Connect the power supply unit to a suitable
power source
• Call a specialist if necessary
• Connect/repair boundary wire
• Replace blades
• Set the correct date and time
• Adapt the terrain/obstacle to the requirements
of the robot mower
• Adjust the laying of the boundary wire accord-
ingly