Unpacking; Assembly / Before Commissioning - Scheppach XXL900 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Total weight (net)
Technical changes reserved!
m IMPORTANT:
This charging unit is suitable exclusively for charging
the product type RoboCut XXL 900.
Noise & vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB (A),
please wear suitable hearing protection.
Device emissions values
Measured sound power level
Device emissions values uncertain-
ty K
WA
Guaranteed sound power level
Sound pressure noise level at the
operator's ear
The noise emission declaration complies with stand-
ard EN ISO 3744

7. Unpacking

• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for trans-
port damage. In the event of complaints the carrier
must be informed immediately. Later claims will not
be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number
as well as type and year of manufacture for the
product.
m ATTENTION!
The device and the packaging material are not
children's toys! Do not let children play with
plastic bags, films or small parts! There is a dan-
ger of choking or suffocating!
26 | GB

8. Assembly / Before commissioning

approx. 8 kg
m ATTENTION!
Always make sure the product is fully assembled
before commissioning!
m ATTENTION!
If you intend to use a scarifier within the working
area of the robotic mower, the boundary wire (11)
must be buried.
m ATTENTION!
Do not use a strimmer near the boundary wire
(11). Take care when trimming edges near which
the boundary wire (11) is located.
60.65 db(A)
0.7 db(A)
8.1 Setting up / correct position of the charging
61.4 db(A)
50 db(A)
m ATTENTION
Fix the charging station (10) in place with the
help of a hammer (not included in delivery) and
the anchor pegs (13) only after you have staked
out the complete working area.(Fig. 16).
m NOTE:
Do not make new holes in the charging station.
m NOTE:
Do not stand with your feet on the charging station
plate.
m ATTENTION
The extension cable as well as the mains cable
must be outside the working area to ensure that
it is not damaged.
• The charging station (10) can be placed near a
• The charging station (10) must be placed on lev-
• The charging station (10) must be set up/positioned
www.scheppach.com
station (10)
shed, a garden shed or the house.
el ground.
m NOTE:
Do not place the charging station (10) on a slop-
ing or uneven surface, otherwise it will bend and
the function will be impaired or a defect may occur.
such that there is at least one metre of space in
front of the charging station (10), without obstacles
or similar. (Fig. 3)