Preparation; Control Elements; Configuring The Shavings Ejector; Rotating Or Replacing The Planer Blades - Parkside PHA 12 B2 Originalbetriebsanleitung

accessories may cause electric shock
or fire.

Preparation

WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.

Control elements

Familiarise yourself with the operating ele-
ments before using the device for the first
time.
Cutting depth adjustment
• A rotary knob can be used to adjust
the cutting depth (1).
• The depth of cut can be adjusted to
between 0 and 2 mm.
• The best cutting depth is between 0
and 1.2 mm (green section of the scale
on the rotary knob).
Configuring the shavings
ejector
Options
There are 3 options for configuring the
shavings ejector:
• Ejection of shavings on both sides
without insert in the shavings ejector
• Ejection of shavings on one side with
directional insert
• Extraction with dust extraction adapter
Extraction is recommended if dust is to
be expected.
Inserting the directional insert
The directional insert (15) can be inserted
from both sides.
1. Push the directional insert as far as it
goes into the shavings ejector (13)
from the side that you want to close
off.
There are grooves in the shavings eject-
or to ensure correct positioning.
Inserting the dust extraction ad-
apter
The dust extraction adapter can be inser-
ted from both sides.
1. Push the dust extraction adapter (16)
with the opening pointing downwards
(⊓) into the shavings ejector (13).
2. Connect the dust extraction adapter to
a suction hose (e.g. PARKSIDE wet/dry
vacuum).
3. Make sure that the dust extraction sys-
tem is suitable for the material to be
cut. This information can be found in
the operating instructions of the extern-
al device.
Rotating or replacing the
planer blades
WARNING! Risk of injury due to
unintentional start-up. Remove the re-
chargeable battery from the device.
CAUTION! Cutting injuries! Do not
hold the planer blade by its cutting edges.
Notes
• The blades have two cutting edges,
which can be turned around.
• Always rotate or replace the planer
blades in pairs.
• Do not attempt to sharpen the planer
blades!
• Always change the planer blades one
after the other. In this way, you can use
the one that is still installed to guide
you during fitting.
• For replacement planer blades,
see Spare parts and accessories,
p. 33.
Dismantling the planer blade (fig.
A)
1. Set the cutting depth adjustment (1) to
0.
GB
27