Replacing The On-Board Computer Batteries; Adjusting The E-Bike; Saddle (Height, Position, Suspension If Applicable) - dutch id FLOW Bedienungsanleitung

If you do not disconnect the charger after charging, the charger will automatically turn on
4
again after several hours, check the battery level and begin charging again if necessary.
4.6. Replacing the on-board computer batteries
The on-board computer works on two 3 V CR2016 coin cell batteries. You should replace the
batteries yourself when they are empty.
1. Unscrew the screw of the on-board computer holder.
2. Use a coin or other firm thin object to unscrew the battery cover.
3. Replace the two coin cell batteries. Note the battery polarity.
4. Close the battery cover and remount the on-board computer on the handlebar in the required
position.
The e-bike will automatically turn off to save energy after 10 minutes of inactivity.
4
4.7. Adjusting the e-bike
4.7.1. Saddle (height, position, suspension if applicable)
You can adjust the saddle in three ways:
Ҍ height of the saddle.
Ҍ angle of the saddle.
Ҍ moving the saddle forwards or backwards.
4.7.1.1. Height
Adjust the height of the saddle so your knee is slightly bent.
1. Place the e-bike on the stand.
2. Slightly loosen the Allen key of the saddle clamp 7.
3. Stand next to the saddle of the e-bike.
4. Adjust the saddle y to the desired height.
Generally, the correct saddle height is hip height when standing next to the bike.
4
CAUTION
6
Do not pull the seatpost out of the frame beyond the "MIN" marking on the seatpost.
72