Rapid EG380 Betriebsanleitung Seite 6

gravity, onto a disposable
support (container, paper,
cardboard,..).
- Start to push the glue by
pressing lightly on the trigger
from time to time. Continue
to let the tool warm up and
repeat this action until it
unblocks. Pull the trigger
a few times, to make sure
that the old glue has been
completely cleared and the
tool has been completely
purged.
* Charring of the glue, depending
on the nature and composition
of the glue used, occurs when
the glue remains molten,
trapped inside the tool, for too
long. Once charred, the glue
will begin to obstruct the nozzle
and thus lead to a glue leakage
of glue towards the back of the
tool which in the long-term can
be serious consequences such
as a system blockage at the
front or a break in the heating
system.
In this event:
- Remove the nozzle, beware
with the device being hot.
- Place the tool on its stand.
Leave it plugged in and
heated. Purge the tool by
letting the hot glue flow
out under gravity, onto a
disposable support (container,
paper, cardboard,..).
- Insert a new glue stick,
pushing lightly on the trigger.
- Pull the trigger a few times,
to make sure that the old
glue has been completely
cleared and the tool has been
completely purged.
- Replace the nozzle with a new
one.
• In any case, you should never:
- Force the trigger before the tool
has heated up to its working
temperature
- Push hard on the glue stick,
never attempt to remove it from
the back.
• Repair work on the glue gun
should be carried out by qualified
staff only.
• If the power supply cable is
damaged it must be replaced
by the manufacturer, the
manufacturer's after sales service
or a similarly qualified person in
order to avoid any danger.
Electric wiring diagram
220-240V 200W
Heating
Heating
picture needed
220-240V 200W
ON/OFF Switch
ENVIRONMENT
Separate Collection. Do not
dispose power tools into
household waste! According
to the European Directive
2012/19/EC on waste of electrical
and electronic equipment.
When the tool needs to be
replaced, or if it is of no further use
it should be brought to a separate
collection centre for recycling.
Thermostat
TS
Fuse
AC 220~240V
7