Rapid EG380 Betriebsanleitung Seite 4

• It is normal for this tool to become
quite warm during use. This is
normal and does not indicate a
problem.
• Hot Surfaces: the nozzle of
the appliance and the glue
can reach a temperature of
approx. 220°C. Do not touch the
heated nozzle or the hot adhesive.
Avoid any contact with the skin. If
you burn yourself, put the burn in
cold water immediately. Never try
to remove a large quantity of glue
without medical help.
• Keep children away. Children
should not use this glue gun.
• When applying at a height, take
all the necessary precautions to
ensure that the glue does not
run onto the operator or onto any
object. Make sure that you have
enough protection wear (skin,
eyes)
• Some materials are heat-sensitive
and can be damaged by the
hot nozzle or even the hot glue.
Whenever possible, test a piece
of scrap material or a hidden
portion of the object being
repaired.
• Stay alert. Pay attention to your
work. Beware of any dripping
hot glue from your project. Use
common sense. Do not operate
this gun when you are tired. Do
not operate under the influence
of alcohol or other drugs that may
impair your physical abilities.
• When you have finished using the
machine, unplug it and wait until it
has cooled. Never immerse glue
gun in water or other liquids to
speed cooling process. Allow it to
air cool only. The glue gun should
be stored in a closed dry and
secure place (tool box, drawer,
cupboard, etc.).
Instructions for Use
Temperature
adjustor
Trigger
ON/OFF switch
• Plug the glue gun into a suitable
socket, red light on means the
power is on.
• Allow the tool to heat for
approximately 3-5 minutes. Insert
a glue stick in the back of the tool.
• When the gun is fully heated,
squeeze the trigger slowly, until
the melted material begins to
fl ow from the nozzle. Release the
trigger to stop the glue fl ow.
• Set the temperature button to
adjust the operating temperature
between 140-220° C.
• Work with glue gun trigger to
adjust the output and speed of
the glue stick.
Temperature control
• To change the nozzle, the glue
gun should be slightly warm but
unplugged.
• Unscrew the nozzle using gloves.
Glue feeding
direction
Power input
Changing Nozzle
5