Rotating The Display; Parameter Set Up; Care And Cleaning - Braun Pulse Oximeter 1 Bedienungsanleitung

Keep finger steady while taking a measurement.

Rotating the display

If you want to change the display direction, press
and release (approx. 1 second) the Power/Menu button on the front
panel. The display can be viewed in 6 different orientations.

Care and cleaning

Use 70% alcohol to clean the pulse oximeter finger insert area and
your finger, before and after each test.
6

Parameter set up

Press the Power/Menu button to turn on
the device. With the device turned on,
press and hold the Power/Menu button to
change the display mode.
Press and hold the Power/Menu button
(approx. > 3seconds) until you enter the
parameter setup menu 1 and hold down again (approx. 3 seconds)
to enter screen 2.
Settings
Alm Setup
*
off
Alm
off
Beep
off
Demo
OK
Restore
3
Brightness
Exit
1. In menu 1 or 2 press the Power/Menu button to cycle through
the various parameters. You will see the * move to each
parameter as you cycle through. When you are at the parameter
you wish to change, press the Power/Menu button for 3 seconds
to change the parameter setting.
2. If you wish to restore to factory settings, move the * to the restore
selection on menu 1 and hold the Power/Menu button down for
approximately 3 seconds.
3. To exit the menus and return to the measurement screen, move
the * to the exit selection on menu 1 or 2 and hold the Power/
Menu button for 3 seconds, or simply wait 10-12 seconds
without interacting with device and it will return to the
measurement screen.
Attention
If using device outdoors or under strong light, please increase the
screen brightness to improve legibility.
Choose a lower screen brightness to conserve battery power.
English
Sp0 PR
% bpm
2
-- ---
Settings
Sounds Setup
*
100
Spo2 Alm Hi
85
Spo2 Alm Lo
130
PR Alm Hi
50
PR Alm Lo
+
+/-
Exit
7