Scheppach HSM3500 Original Bedienungsanleitung Seite 30

• Observe the motor and diamond cutting wheel di-
rection of rotation.
• Only cut one workpiece at a time.
• The cut path must be kept of obstacles above and
below.
• Make sure that you can remove cut workpieces from
the cutting wheel from the side in order to ensure
that avoid becoming entangled.
• Only work with diamond cutting wheels which are
exclusively suitable for wet cutting.
• Use diamond cutting wheels which are the correct
size.
• Keep you hands, fingers and arms away from the
rotating cutting wheel. Always maintain sufficient
clearance from the diamond cutting wheel.
• Replace faulty diamond cutting wheels immediate-
ly. Deformed or cracked cutting wheels may not be
used.
• Only use diamond cutting wheels recommended by
the manufacturer which conform to EN 13236. The
use of any type of saw blades is prohibited.
• Make sure that a suitable diamond cutting wheel for
the material to be cut is selected.
• Do not use the stone cutting machine without safety
equipment.
• Always switch off the machine and pull out the
mains plug for the correction of errors or removal
of jammed workpieces. Only remove the jammed
workpiece after doing so.
• Protect the diamond cutting wheel from impact and
jarring. Do not subject it to any lateral pressure.
• Do not stress the device to the extent that it is
brought to a stop.
• Wear suitable personal protective equipment (PPE).
- Hearing protection to avoid the risk of becoming
hearing impaired.
Attention! Noise can be harmful to the
health. If the permissible noise level of 80
dB(A) is exceeded, hearing protection must
be worn.
- Respiratory protection to avoid the risk of inhal-
ing harmful dust.
- Eye protection to avoid the risk of injuring the
eyes.
- Gloves are recommended when handling raw
materials and shoes with non-slip soles when
working outdoors.
• Diamond cutting wheels must always be carried in a
container whenever practical.
• This machine may only be operated by persons who
are familiar with stone cutting machines.
30 | GB
• Errors in the machine, including all covers and pro-
tective devices must be reported to the person re-
sponsible for safety as soon as they are discovered.
• Do not leave the device running unattended.
OTHER SAFETY INSTRUCTIONS
Please read all the instructions before using this prod-
uct!
Workplace
To rule out the risk of physical injury, machine damage,
fire and electric shock, please ensure that your work-
place is protected
• against humidity, wetness and rain,
• It is free of Inflammable gases and liquids,
• It is protected from children – use padlocks and
the master switch when the machine is not in use;
• It is clean and empty,
• It is well-ventilated and illuminated.
The operators
Healthy commonsense and caution are factors that
cannot be integrated in a machine. These factors are
the responsibility of the operator. Please consider the
following:
• Prevent body contact with grounded surfaces such
as pipes and radiators.
• Please be watchful. Do not work at the machine if
you are tired.
• Do not operate the product under the influence of
alcohol or drugs. Read the warning instructions to
determine whether your judgement or your reflexes
could be affected.
• Do not wear loose clothing or ornaments which can
get entangled in rotating components.
• Anti-skid shoes are recommended.
• Protect long hair with suitable means.
• Wear eye- and ear protection. Always wear:
- ANSI- approved dust masks.
- Hearing protection.
• Always maintain your balance.
• Do not stretch yourself over running machines.
Residual risks
The machine is built according to the latest tech-
nology and the recognized technical safety-relat-
ed rules. Nevertheless, individual residual risks
can occur during operation.
• Danger of Injury to fingers and hands from the run-
ning tool if it is used incorrectly.
www.scheppach.com