Battery Status, Status Indication And Charging - Vermeiren Sedna Gebrauchsanweisung

EN
NL
3.6

Battery status, status indication and charging

3.6.1 Battery status and status indication
The indicator lights of the status indication and battery status will go on as soon as the scooter is
switched on, see next figure.
•
Check if all lights are on (if the battery is fully charged, see next)
Battery-status and status indication
Status (fault) indication (16)
Battery-status indication (17)
3.6.2 Removing and replacing battery
The key to switch the scooter on is also to be used to unlock the battery.
To remove battery (18) from the scooter:
•
Put the key in the lock and turn the key counter clockwise
(position A).
•
The battery is now unlocked and can be lifted from the
scooter by the handle.
To replace the battery:
•
Make sure that the key is in the "unlocked" position.
•
Place the battery in the housing of the scooter.
•
Turn the key clockwise (position B) to block the battery.
•
Check the battery to be locked.
16
These red lights go on by switching the scooter on and next they go out.
In case of any problem these lights will blink slowly. The number of
blinks indicate the fault code. The meaning of this code can be found in
chapter 5.
The battery-status lights will go on from left to right after switching on.
When the battery is fully charged, all blocks/lights will be on. Using the
scooter will decrease the battery charge and some of the lights on the
right will go out. The more lights are on, the higher battery charge is.
The batteries need to be charged again If only 3 red lights on the left
are on. Keep in mind that the scooter will automatically stop during the
ride when battery charge becomes to low.(see chapter 3.6)
Lock-unlock battery
16
17
Sedna
2023-05
Using your scooter
18