EINHELL FQ-SKS235 Bedienungsanleitung Seite 132

sleeves or adapters to make grind-
ing wheels with larger holes fit
properly.
i) Ensure that the tool is securely fas-
tened to a workbench.
j) Take care that the sparks gener-
ated during use do not cause any
danger, e.g. by hitting persons or
igniting inflammable material.
k) The tool runs on after it has been
switched off. Wait for the complete
stop of the grinding wheel before
leaving the tool.
l) Disconnect tool from mains sup-
ply. Switch off and wait for the tool
to come to a complete standstill
before leaving it unattended. Un-
plug the tool when not in use, be-
fore servicing or changing acces-
sories.
m) Always use proper accessories
and attachments with this tool.
The use of any accessory or at-
tachment or performance of any
operation with this tool, other
than those recommended in this
instruction manual may present a
risk of personal injury.
n) Check for damaged parts. Before
using the tool, carefully check it
for damage to ensure that it will
operate properly and perform its
intended function. Check for mis-
alignment and seizure of moving
parts, breakage of parts and any
other conditions that may affect its
operation. Have damaged guards
or other defective parts repaired
or replaced as instructed.
o) Never transport or run the tool
without all guards in place and in
perfect working condition. Guards
ensure that the tool can be oper-
ated in its most safe condition.
p) Keep your hands well clear off
the grinding wheel. The grinding
wheel is sharp. Coming in contact
with it may cause serious injury.
q) Always use the chain clamp. A se-
EN
132
cured chain prevents slipping and
provides better results.
RESIDUAL RISKS
In spite of the application of the rel-
evant safety regulations and the im-
plementation of safety devices, cer-
tain residual risks cannot be avoided.
These are:
- Impairment of hearing if not wear-
ing hearing protection.
- Risk of accidents caused by the un-
covered parts of the rotating grind-
ing wheel.
- Risk of thrown parts from damaged
grinding wheels.
- Risk of thrown workpieces and
parts of the workpiece.
- Health hazards caused by breathing
in dusts developed during work.
ADDITIONAL SAFETY
TIONS ON RISKS DUE TO VIBRA-
TION
a) The declared vibration data repre-
sents the main applications of the
appliance, but different uses of the
appliance or poor maintenance
can result in different vibration
data. This may significantly in-
crease the vibration level over the
total working period.
b) Additional safety measure shall be
taken to protect the user from ef-
fects of vibration. Maintain the ap-
pliance and its accessories, keep
hands warm and organize work
patterns and periods.
INSTRUC-