Checchi & Magli DUAL 12 GOLD Bedienungs- Und Wartungsanleitung Seite 73

Tyre check
Check the tyres for wear and if they feature tears or signs
of ageing, they must be replaced.
Check tyre pressure and restore if necessary (see "Tech-
nical characteristics" schedule).
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
Troubleshooting
The following list contains a number of common problems that may arise during work, together with the ways to
solve them.
Problem
The seedling planted is too close
to the surface or too deep
The soil has not been properly
compacted on top of the seedlings
The seedling is planted at an angle
English language
MAINTENANCE INFORMATION
The pressure must be checked with the weight of the
work vehicle entirely on the ground and with nothing
and nobody on the work vehicle.
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication diagram").
Likely cause
Incorrect planting depth
The dispenser is not synchronised
with the ejector
The packing wheels are not
properly adjusted
The dispenser is not synchronised
with the ejector
The plant control plate is not in the
right position
31
Solution
Make the relative adjustment (see
"Adjusting the planting depth")
Adjust the timing (see "Dispenser/
ejector timing adjustment")
Adjust the packing wheels (see
"Adjusting the spacing between the
packing wheels and the ploughshare")
Adjust the timing (see "Dispenser/
ejector timing adjustment")
Adjust the plant control plate (see
"Plant control plate adjustment")
7
Use and maintenance