Switching On - Sentiotec Wave.com4 Montageanleitung

Instructions for assembly and use

3.3.0 SWITCHING ON

The control unit must be connected to the power supply.
The left symbol illuminates constantly. If the time symbol also illuminates, the
automatic switch-on or pre-set time (programming see Point 3.12.0 of these operating instructions)
is active and the control unit will switch on after the displayed time.
Pressing the key switches the control unit on and the cabin light connected to the control unit
starts to illuminate. The operating mode (see Point 3.4.0 of these operating instructions) must then
be selected.
WE DO IT FIRST.
22 /228