Other Settings - Omnitronic Key-288+ Bedienungsanleitung

7.14 Other settings

7.14.1 Store all parameters
7.14.2 Recall all parameters
7.14.3 Reset
7.14.4 Sequencer remote control buttons
Press the MENU button repeatedly until the display reads "Store all
parameters" to start the function of storing parameters. It stores 3
groups setup value. When this function is valid, the display reads
"Store all parameter" and the current storage group number. It can be
adjusted via the value dial and confirmed by the Enter button. The
initial value is 1, adjusting scale is 1～3. The operating steps and the
display are shown on the left.
(1) Press the MENU button repeatedly until the display reads "Store
all parameter".
(2) Rotate the value dial to adjust the memory area and the display
shows the current memory area.
(3) Press the "Enter" button to confirm and the display shows "Done".
Hold the "Enter" button for 2 seconds to exit the edit mode and
return to parameter display mode. Then if you rotate the knobs,
move the sliders or trigger the pads the display will show the
current parameters of these controllers.
Press the MENU button repeatedly until the display reads "Recall all
parameter" to start the function of recalling all parameters. When this
function is valid, the display reads the "Recall all parameter" and the
current storage group number. It can be adjusted via the value dial
and confirmed by the Enter button. The initial value is 1, adjusting
scale is 1～3. The operating steps and the display are shown on the
left.
(1) Press the MENU button repeatedly until the display reads "Recall
all parameter".
(2) Rotate the value dial to select the memory area and the display
shows the current memory area.
(3) Press the "Enter" button to confirm and the display shows "Done".
Hold the "Enter" button for 2 seconds to exit the edit mode and
return to parameter display mode. Then if you rotate the knobs,
move the sliders or trigger the pads the display will show the
current parameters of these controllers.
Press the MENU button repeatedly until the display reads "Reset all"
to reset the system restoring to factory setting, sending system initial
setting info at the same time. When this function is valid, the display
reads "Reset all". It can be confirmed by the Enter button. The display
is as shown on the left.
There are 2 buttons used for Playback and Record control: [>>], [O]. It
is common to set the 2 buttons as Sequencer remote control buttons,
it needs to be working with sequencer software.
36 • EN