Assignable Knobs; Assignable Sliders - Omnitronic Key-288+ Bedienungsanleitung

7.4 Assignable Knobs

7.5 Assignable sliders

There are 4 knobs that can be assigned as controller No.
independently. Press the MENU button repeatedly until the displays
reads "CC NUMB/Pad note", then rotate the knobs you wish to
program. Input the desired controller value with the value dial and
confirm the value with the "Enter" button.
For example, you may want to set Knob1 to control the channel
volume. This is done by assigning controller 7 to Knob1 (first on the
left). The operating steps and the display are shown on the left.
(1) Press the MENU button repeatedly until the displays reads
"Control assign CC NUMB/Pad note".
(2) Rotate R1 knob (first on the left).
(3) Rotate the value dial until the displays reads "007". The numbers
are the controllers.
(4) Press the "Enter" button to confirm and the display shows "Done".
Hold the "Enter" button for 2 seconds to exit the edit mode and
return to parameter display mode. Then if you rotate the knobs,
move the sliders or trigger the pads the OLED will display the
current parameters of these controllers.
There are 4 sliders that can be assigned as controller No.
independently. Press the MENU button repeatedly until the displays
reads "CC NUMB/Pad note", then move the sliders you wish to
program. Input the desired controller value with the value dial and
confirm the value with the "Enter" button.
For example, you may want to set Slider F1 to control the expression
control. This is done by assigning controller 11 to F1 (first on the left).
The operating steps and the display are shown on the left.
(1) Press the MENU button repeatedly until the displays reads
"Control assign CC NUMB/Pad note".
(2) Move the F1 slider (first on the left).
(3) Rotate the value dial until the displays reads "011". The numbers
are the controllers.
(4) Press the "Enter" button to confirm and the display shows "Done".
Hold the "Enter" button for 2 seconds to exit the edit mode and
return to parameter display mode. Then if you rotate the knobs,
move the sliders or trigger the pads the display will show the
current parameters of these controllers.
31 • EN