Transpose; Program Change; Midi Channel - Omnitronic Key-288+ Bedienungsanleitung

7.10 Transpose

7.11 Program change

7.12 MIDI channel

Press the MENU button repeatedly until the display reads "Transpose"
to start the function of Transpose. This function allows the keyboard to
change the Pitch up/down by semi-tone. When this function is valid,
the display shows the "Transpose" and the value of current transpose.
It can be adjusted via the value dial. The initial value is 0, adjusting
scale is -12～12. The operating steps and the display are shown on
the left.
(1) Press the MENU button repeatedly until the display reads
"Transpose".
(2) Rotate the value dial to adjust the keyboard transpose, the display
shows the current transpose. Hold the "Enter" button for 2
seconds to exit the edit mode and return to parameter display
mode. Then if you rotate the knobs, move the sliders or trigger the
pads the display will show the current parameters of these
controllers.
Press the MENU button repeatedly until the display reads "Program
change" to start the function of Program change. Program change is
for adjusting the voice of the current channel. When this function is
valid, the display reads the "Program change" and the current voice
number. It can be adjusted via the value dial and confirmed by the
Enter button. The initial value is 1, adjusting scale is 1～128. The
operating steps and the display are shown on the left.
(1) Press the MENU button repeatedly until the displays reads
"Program change".
(2) Rotate the value dial to adjust the keyboard program, the display
shows the current keyboard program.
(3) Press the "Enter" button to confirm and the display shows "Done".
Hold the "Enter" button for 2 seconds to exit the edit mode and
return to parameter display mode. Then if you rotate the knobs,
move the sliders or trigger the pads the display will show the
current parameters of these controllers.
Press the MENU button repeatedly until the displays reads "MIDI
channel" to start the function of Channel selection. Channel selection
is for adjusting the current MIDI channel. When this function is valid,
the display shows the "MIDI channel" and the current channel number.
It can be adjusted via the value dial and confirmed by the Enter
button. The initial value is 1, adjusting scale is 1～16. The operating
steps and the display are shown on the left.
(1) Press the MENU button repeatedly until the displays reads "MIDI
channel".
(2) Rotate the value dial to adjust the keyboard MIDI channel, the
display shows the current MIDI channel.
(3) Press the "Enter" button to confirm and the display shows "Done".
Hold the "Enter" button for 2 seconds to exit the edit mode and
return to parameter display mode. Then if you rotate the knobs,
move the sliders or trigger the pads the display will show the
current parameters of these controllers.
34 • EN