Editing Method Steps - struers TegraDoser-5 Gebrauchsanweisung

Editing Method Steps

38
TegraDoser-5
Instruction Manual
Before starting to edit the process parameters for the individual User
Method Steps, please note that the parameters displayed vary
depending on the type of "Surface:" and "Suspension:" defined. In
the screen illustration below, the surface selected requires both an
abrasive suspension and a lubricant, but this is not always the
situation.
There are 2 types of polishing surfaces: Abrasive Surfaces and Non-
abrasive Surfaces. Depending on which one is selected determines
what is displayed in the EDIT METHOD menu.
The table below provides a basic overview of the polishing surfaces
and the parameters, which are displayed, when they are selected.
When "Not required" is indicated in the table, then the line including
this parameter, for example "Suspension" is omitted in the screen
display.
Type of Surface
Abrasive surface
Non-abrasive surface
Requires
Suspension
Not required
Diamond susp.
DiaPro or DiaDuo
(All-in-one products)
Diamond susp.
(water based)
Diamond susp.
(water-free)
Oxide susp.
Lubricant
Water only
Not required
Water-based
Water-free
Not required