Starting The Process; Changing Parameters While The Process Is Running - struers TegraDoser-5 Gebrauchsanweisung

Starting the Process

Changing parameters while the
process is running
20
TegraDoser-5
Instruction Manual
Once the desired preparation method/step has been selected, insert
the correct preparation disc on the TegraPol's turntable and press

on the TegraPol's control panel to start the turntable
Start
rotating.
If water is required to an otherwise dry process, press  to override
the process settings and apply water. This occurs as long as  is
held.
If you run two successive preparation steps with the same surface,
suspension and lubricant, the machine will NOT stop between these two
steps, they are considered to be 2 phases of the same step.
However, to stop the machine between two such steps,
e.g. to exchange Sic-Paper, select this setting in the
Please see the TegraPol Instruction Manual for details.
While a preparation step is running it might be necessary to change
some of the parameters. The only parameters that can be changed
in a step that is running are: force and dosing level. To change other
parameters the process must be stopped. For fast access to the
active method select either Struers Methods or User Methods and

press ENTER .
While a method is running, F2 Process provides a shortcut to the
step running at the moment. Thus immediate access to the
parameters to be changed is possible.
Important!
TegraPol configuration menu.