7-Nozzle Dosing Head; Fitting The Dosing Head To The Tegraforce - struers TegraDoser-5 Gebrauchsanweisung

7-nozzle Dosing Head

D-sub connector
on TegraForce
Fitting the Dosing Head to the
TegraForce
Dosing head
after installation
Dosing nozzle arm
6
TegraDoser-5
Instruction Manual
TegraDoser-5 comes complete with a 7-nozzle dosing head and
tubing to allow it to be mounted on the TegraForce.
The length of the tubes between TegraDoser-5 and the dosing head
determine the distance between the TegraForce and TegraDoser-5.
The factory-mounted tubes are of optimal length and it is not recommended
Swing the dosing nozzle arm aside to gain access to the D-sub

connector.
Insert the dosing head into the recess on the side of the

TegraForce.
Press downwards until the dosing head is in position.

Insert the included screw and tighten it to secure the dosing

head.
Swing the dosing nozzle arm back into position under the body

of the dosing head.
Make sure that the tubes from TegraDoser-5 are not taut so that

the TegraForce can be turned freely.
Note
that this length be increased.