Unpacking Tegradoser-5; Placing Tegradoser-5; Electrical Connections; Supplying Water (Op Versions Only) - struers TegraDoser-5 Gebrauchsanweisung

Unpacking TegraDoser-5

Placing TegraDoser-5

Electrical Connections

Supplying Water
(OP versions only)
TegraDoser-5
Instruction Manual
Remove TegraDoser-5 from the foam packing.
Place TegraDoser-5 as close to the TegraPol as possible without it
interfering with the operational condition of the TegraPol.
The tubes between TegraDoser-5 and the TegraPol are pre-fitted on
delivery. These tubes limit the distance between the two units.
There is a single electrical connection between the TegraPol and
TegraDoser-5. This provides both the 24V power supply to
TegraDoser-5 and a data bus, which enables the two machines to
communicate together.
Switch off the TegraPol.

Use the single cable attached to the rear of TegraDoser-5 and

connect it to the Doser connector on the rear of the TegraPol. To
locate this connector, refer to the diagram of the rear of the
machine in the TegraPol manual.
A water supply is only required when an OP pump is fitted on
TegraDoser-5. This comes directly from the TegraPol.
Push the water tube supplied into the quick fit connector on the

rear of the TegraPol.
Take the other end of the water tube and push it into the quick fit

connector on the rear of TegraDoser-5, refer to the diagram of
the rear of TegraDoser-5 on page 4.
Do not push the water tube all the way into the connector as that
might squeeze the tube and reduce the water flow.
To adjust the water flow, use the built in regulator at the back of

the TegraDoser-5.
Note
5