Husqvarna Automower EPOS Plug-in Kit Bedienungsanweisung Seite 114

1. Hold the arm for the reference station on the wall
where you will attach it. Make 4 marks on the wall
where you will attach 4 screws.
Note:
If the reference station is installed on a
wall the top of the reference station must be above
the wall.
2. Drill 4 holes in the wall for the 4 screws.
3. Install the reference station on the wall with 4
screws.
4. Put the cable of the reference station through the
slot in the arm and install the reference station on
the arm.
114 - Installation
5. Attach the connector to the clips on the arm.
6. Tighten the screw (Torx 20) on the arm of the
reference station.
T20
1944 - 001 - 13.01.2023